ACTIVATION
Setting up your new VOIP Freedom service is simple.
Using
the following installation instructions, you can be up and running
within minutes! Make phone calls to all of your friends and start
setting up all of your cool new features to make VOIP Freedom even more
reliable and fun to use! Before you begin please make sure you have a
working and active Internet connection.
1
. Locate your Account Details that were sent after signing up.
2
. Call our toll free customer service to activate your linsys adapter on our network.
3
. Make sure that the address where the
phone will be installed is correct with our representative. This address will be sent to 911.
Please double check address before you activate your account.
4
. You will be asked to provide the MAC address of your
device, it can be found on the bottom of your device, as shown on the
picture below.
5
. After activation of your account you can begin installation of your phone adapter.
INSTALLATION OF YOUR PHONE ADAPTER
1. If your computer connected to modem through router you should do following:
A.
Power off your network devices, including your modem and PC.
B.
Disconnect cable between modem and router, from port marked as WAN on
your phone adapter, then connect it to port INTERNET on your phone
adapter.
C.
Connect
one end of the Ethernet network cable (included) to the ETHERNET port
of the Phone Adapter. Connect the other end to the Ethernet port of
your router.
D.
Connect one end of a different Ethernet network cable to the INTERNET
port of the Phone Adapter. Connect the other end to your cable/DSL
modem.
Connect any regular phone to port Phone1.
E.
Power on your adapter.
F.
Plugin, with 30 seconds interval, all your devices: modem, phone adapter, router, computer.
G .Check if the internet on your computer is working.
H. On your phone adapter two green lights, Power and Network, will be on.
After finishing all steps, leave your adapter on;
activation may take up to 60 minutes. Your phone will be ready to use
when light PHONE1 is green. If you bought two lines the PHONE2 light
will be green aswell. If after 60 minutues activation was not completed
reconnect power on your phone addapter.
•
The Linksys SPA 2102 is ready when the PHONE 1 light on the top of the
adapter is blue. This may take up to 1 hour, as the adapter needs to
register with VOIP Freedom's system. Once the Power LED, Ethernet LED,
and Line 1 LED are solid blue then your phone is ready to make and
receive calls. When the PHONE 1 light is solid confirm your Internet
connection
.
2. If you do not have a router, you should do following:
A. Power
off your network devices, including your modem and PC.
B.
Disconnect cable between
modem and computer, from port marked as WAN on your phone adapter, then
connect it to port INTERNET on your phone adapter.
C. Connect
one end of the Ethernet network cable (included) to the ETHERNET port
of the Phone Adapter. Connect the other end to the Ethernet port of
your PC.
D. Connect
one end of a different Ethernet network cable to the INTERNET port of
the Phone Adapter. Connect the other end to your cable/DSL modem.
Connect any regular phone to port Phone1.
E. Power on your adapter.
F. Plugin, with 30 seconds interval, all your devices: modem, phone adapter, router, computer.
G.
Check if the internet on your computer is working.
H.
On your phone adapter two green lights, Power and Network, will be on.